Easy Tie-As-You-Go Way to Tie a Quilt - Tutorial

You know the old saying, "There's more than one way to skin a cat."  Well, the same holds true for tying a quilt.  "There's more than one way to tie a quilt" and I would like to share with you one of my favorites.  "Why is it my favorite?" you may ask.  Well, being lazy by nature, I don't like the tie and cut, tie and cut, tie and cut method because I don't like having to set down and pick up my scissors that often.  I like to do one thing for a while and then go on to the next.

The problem I have with the method of taking all the stitches, cutting between each of them, and then tying them (though I prefer that to the first method above), is that I invariably forget to tie one and it gets pulled out by a child.  In this method, you tie as you go.

1. Start by taking a stitch and pull the yarn/floss or whatever you like to use a few inches from the end.

 2. Tie a square knot.  Remember that each time you tie a knot, it should be a square not and you need to pull equally from both sides.

















 3. Move to the next place and take a stitch.

 4. Pull taut.

 5.  Tie the knot as follows:
Circle the yarn up and to the left.
Come under the taut line and over your circle.















6.  Pull the first part of the knot tight.  Though I don't show it (because my hand got in the way of me taking the picture), tighten the knot by pulling on both the needle end as well as the taut end.











7. Finish tying the knot:
Next circle the yarn down to the right (opposite the direction you went before).
Go under the taut string, and over the circle.


Think as you tie: "Circle Left, Under, Over.  Circle Right, Under, Over."








8. Pull the knot tight.  Remember to pull the yarn equally on both side of the knot.

9. Continue until you run out of yarn to tie a knot.  Then Cut halfway between each knot and trim to the desired length.

Navy Veranda Blouse - Trenna / Bonus photos from the shoot

This blouse Emerald made from the Michael Miller navy Veranda fabric for Trenna.  It was made from the on-line only Burda pattern: Modell 107 Burda Style 12/2014.

Below are some pictures from the Veranda photo shoot.

Little girl's dress Veranda and Sweet Vine - Trenna / Bonus photo from shoot

Little girl's dress I made for Trenna Travis Design Studio from the Michael Miller Fabrics: White Veranda with trim in Sweet Vine.  Made with the Burda pattern #9470.

Below is a photo from Trenna's shoot.  Gorgeous!

Pink Fanfare dress - Trenna / Bonus photos from the shoot

The fun has begun again.  We've been doing a lot of sewing and have another packed next 3 weeks.  I will try and post when I can, but usually when I'm sewing gang-busters, I don't have much time to post.  This is a dress I made from the Michael Miller Fanfare material for Trenna Travis Design Studio.  We used a Burda pattern that was only available on-line.  It's labeled as follows: Modell 133 Burda Style 8/2012.




















Below are photos from Trenna's Veranda photo shoot.

Scrap Quilt While You Sew Other Projects - Tutorial

I'm all about saving time and money.  When I first heard of chain-piecing, I really latched onto it.  I discovered that not only did it prevent the little bird's nest knot on the underside of the fabric when starting and that it saved thread, (Have you ever noticed how much thread is thrown away as you sew?  You could stuff a doll with it!), but it also kept a whole line of pieces together so I didn't have to get up and down as much as I was sewing.  I could get into my groove and go.

I then learned that if you used a little scrap of fabric - about 1-1.5" wide and sewed over that at the end of the chain, you had all the benefits of chain piecing indefinitely.  Cool.  I was converted to the method.

Then as I was reading a quilting book (Cut the Scraps! by Joan Ford, pg. 35), she mentioned how she always had 2 projects going at once.  The main one and a secondary one that was done over a long period of time.  Here's how it works.
  You are sewing along and come to a place where you need to remove your sewing from the machine.  You reach into your little box of pre-cut pieces and sew a couple together, using these as your holder while you remove your sewing project.  When you begin sewing again, remove the secondary project and put it off to the side.

This first photo is of two scraps I am sewing together to make longer strips. When I have sewn these together, I can remove the black thing behind it that I was sewing.

The second photo is of a little plastic container I use to contain my secondary project.  In this case, I began accumulating 1" strips - things that others were throwing away and I thought, "Surely something can be made from these!"  I think that it's much easier to do this if the secondary project is purely scrappy in design.  You don't want to have to keep two projects in mind and remember which one you are working on.

One inch strips may not be your cup of tea, but choose some scrap project - especially if it's a "grab bag" style, and you can put those scraps to good use. 

What I am doing is sewing 1" x 9" strips together, or if the 1" pieces are smaller than that, I am piecing then together to make longer strips which I then cut down to about 9" strips.  I sew them together, little by little.  When I have 16 strips sewn together, I iron it (I know, I'm waiting until the end), and then trim the square to 8.5" x 8.5."  When I get enough of those squares made, I can make them into a quilt.  I've been working on this for the last 2 years and have 15 squares out of the 80-120 I need to make a full or queen, so it will be a while before I have it complete, but, I love that I can be wasting nothing - no fabric, no thread.

See finished quilt here.

Beach Cover-up for Trenna - Flamingo Border

Emerald, my sister, made this beach dress using the Michael Miller fabric "Flamingo Border" in Seafoam, using the New Look pattern #6803, view C (not the one circled - that was the style she made a year ago).  Pretend that the dress has been ironed. ;-)

Halter Top for Trenna - Clipdot

Made from the Michael Miller Clipdot fabric line in the color "Midnite" for Trenna Travis Design Studio.  I made this back in July 2014 and appears in the Fall Catalog.